Run a script when virtual button is pushed
-
Hi there,
I would like to know if it's possible to present an switch to my gateway / Domoticz and when this switch is pressed in Domoticz it activates a script on the Arduino node which sends a IR signal once.
Maybe it is even possible to distinguish several virtual buttons so several different scripts can run?Because I would like to control my airco unit without the remote from downstairs. So I can turn it on and off or change the temp.
Is there anybody with such a script as a example?
Tnx!
-
@Sander-Stolk You might want to use my RC record and playback project.
http://forum.mysensors.org/topic/2413/ir-record-and-playback-module/7It works also under Domoticz, you might need to add additional switches for start recording.
which sends a MySensor message of type V_IR_RECORD with the preset number as payload.I've just tried a pre programmed version of my RC module with Domoticz and when a preset value is decoded and received by Domitics it creates a Light switch for that code. And when pressing the light tile on Domiticz the RC modules receives back the V_IR_SEND message.
-
There is an example sketch for controlling hvac units.
They are a bit different, in that respect they don't use simple commands like on or off, like TVs do. They transfer a complete setup of temperature, fan speed etc with every button press. So they need a bit more than just record/playback of IR transmission.
-
There is an example sketch for controlling hvac units.
They are a bit different, in that respect they don't use simple commands like on or off, like TVs do. They transfer a complete setup of temperature, fan speed etc with every button press. So they need a bit more than just record/playback of IR transmission.
@tbowmo said:
"They transfer a complete setup of temperature, fan speed etc with every button press."This I noticed because when I remove the battery the next press of a button is indeed temp, flow, speed en dry etc.
I've got the RAW data and I'm sending the RAW data and this works. So I've got a script but I only need a trigger to execute it.
The trigger is the only problem I have. -
@Sander-Stolk You might want to use my RC record and playback project.
http://forum.mysensors.org/topic/2413/ir-record-and-playback-module/7It works also under Domoticz, you might need to add additional switches for start recording.
which sends a MySensor message of type V_IR_RECORD with the preset number as payload.I've just tried a pre programmed version of my RC module with Domoticz and when a preset value is decoded and received by Domitics it creates a Light switch for that code. And when pressing the light tile on Domiticz the RC modules receives back the V_IR_SEND message.
