nano serial gateway behaviour
-
Hi
I had a previously working serial gateway that no longer works, fails radio init fail. all the connections are the same, a capacitor is soldered onto the radio across gnd and 3v3 but the odd thing is that the led is flashing until i connect either putty or serial moniot in which case it goes off. Power led stays on ok and I get the annoying0;0;3;0;9;radio init fail
on which ever I am connecting with. As soon as I disconnect the serial connection the led flashes again. I am waiting for a couple of new nanos so I can't swap over to another one. Any ideas? Is this something that always happens but I haven't noticed it?
-
@mfalkvidd
I have swapped it amd still no good. The one that I swapped with has been working in the past as part of a motion sensor. Bit annoying, going to set another one up with a new capacitor. I don't have any more 4.7, will try a 10, not because I think that is an issue, just because I have to try something and that is the closest to 4.7 i have at the moment. I have a new bag on the way from HK. Will let you know what happens! -
Well, it is working with a new nrf with a 10 uf cap soldered on. Can't understand why swapping for a known good one didn't work but puting in a new one did. The annoyances of building your own stuff I suppose. I will use the original one in something else and see if I can persuade it to work.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login