Working node without MySensors network available

[Alexander Ivanov]

Hi Everyone,

I'm building a light switch which should work even if MySensors network is not available.
What I found in MySensors 2.0 is:

• if there's no network available, the system runs only "before" procedure
• once I power on Ethernet gateway (but I haven't done node inclusion), the system runs "before", "setup" and "presentation" procedures, but doesn't run "loop".

How to enable "loop" for my node even if there's no MySensors network available or/and the node wasn't included to the network?

Thanks
Regards, Alexander

[TheoL]

Dear @Alexander-Ivanov,

Someone asked the same question this week. Continue this thread in that topic https://forum.mysensors.org/topic/4449/how-to-disable-default-node-registration-to-the-gw/2