Sleep issue

[Richard van der Plas]

Having code with a door sensor and a light.
Because i want to save battery time, ive incoporated a sleep mode.
the sleep mode is called after the door is closed, and will wake up again after a change or time ( to measure temperature).
Sleep mode must not be called when the door is open because of the light which should go out after a radio message from the Gateway.

snippet of code:, the 2,5 seconds delay is to make sure the door doesnt open again.

if (gotoSleep == 1) {
     Serial.print("--==## Door closed, Going to Sleep ");
     Serial.println(SLEEP_TIME);
     delay(2500);
     sleep(digitalPinToInterrupt(DOOR_SWITCH), FALLING, SLEEP_TIME);
     gotoSleep =0;
   }

log file shows this:

--==##Door Trigger1
14061 TSF:MSG:SEND,5-5-0-0,s=0,c=1,t=16,pt=1,l=1,sg=0,ft=0,st=OK:1
--## Running  Loop
--==##Door Trigger0
16822 TSF:MSG:SEND,5-5-0-0,s=0,c=1,t=16,pt=1,l=1,sg=0,ft=0,st=OK:0
--==## Door closed, Going to Sleep 
19329 MCO:SLP:MS=300000,SMS=0,I1=0,M1=2,I2=255,M2=255
19333 MCO:SLP:TPD
19385 MCO:SLP:WUP=0

That is so weird, why does it wake again on interrupt (as told by log parser)
CHANGE or FALLING doesn t matter

[Richard van der Plas]

This post is deleted!

[Yveaux]

@Richard-van-der-Plas update to latest MySensors library (2.2.0 beta) and try again please.

[Richard van der Plas]

@Yveaux i dont think i can do that in the online arduino create environment.....

[Yveaux]

@Richard-van-der-Plas probably not, but what you're describing is a known issue in 2.1.x

[Richard van der Plas]

@Yveaux damn is there any other way to fix it besides the 2.2?

[Yveaux]

@Richard-van-der-Plas not that I'm aware of. It's a bug in the library which you cannot fix without touching the library code.

[Richard van der Plas]

@Yveaux Ok went to 2.0 and that indeed works