Mysensors with AT Tiny

[dbemowsk]

This question may have been asked before, but can MySensors work on an AT Tiny with an nRF24?

[mfalkvidd]

@dbemowsk based on earlier threads it should be possible to make it work, but it will require quite a lot of effort and the options will be severely limited (no possibility for debug for example).

https://forum.mysensors.org/post/68052
https://forum.mysensors.org/topic/5043/attiny-13-controller
https://forum.mysensors.org/topic/333/attiny-supported?page=1

[dbemowsk]

My thought was possibly for something like a door/window sensor where all you have is a single magnetic switch, or maybe a plant moisture sensor which is just a two wire probe sensor. Things where you would want the sensor small.

[dbemowsk]

@mfalkvidd Looking at the last link, I doubt I will even try. It was a thought of a way to make smaller simple sensors more than anything. Just brainstorming.
I did some searching before I posted, but did not find those threads. Maybe because I was searching on "at tiny" and not "attiny". Thanks for the links though.

[d00616]

@dbemowsk said in Mysensors with AT Tiny:

It was a thought of a way to make smaller simple sensors more than anything.

@scalz is on the way to create an really tiny sensor. The nRF5 is protocol compatible to nRF24, but have an really powerful CPU inside.

https://forum.mysensors.org/topic/7167/nrf52-recessed-vibration-contact-sensor-for-door-window/1

[dbemowsk]

@d00616 Curious when these might be available for purchase. I like this idea.