💬 MySensors Gateway for Raspberry PI
-
@gohan the spi0 and spi1 busses are two separate devices from the pi's perspective and the two MySensors gateways running*. So if v2 worked with a rfm69, and the v3 extra! wiring is good. (didn't check but 99.9999...%, even the logo is there :-).
Yes it will work. There is no conflict there.- Is it possible to make it one gateway running on the pi for both chips?**
** How do I build a mysensor bridge between 433 and nrf24l01 nodes anyway? I can run domoticz on a pi to be the intermediate. But if I am not running a pi but an arduino gateway?
-
But if someone could enlighten me why I could not use two nrf24l01 devices working on the same bus using the select... (spi0.0 and spi0.1 and using CS?/CE?) (it really seems that data from the two radio's got mangled together somehow, I notice that cuz sometimes it did work... probably when only one radio was sending)
I would me most gratefull :-) -
Hello,
The v1 (without regulator) works for me with an rfm69, so the v2 must work, because is the same wiring. (I have to receive the pcb v2 these days)TriXwood tested the operation of a second module nrf24l01 on the spi1
see https://forum.mysensors.org/topic/7702/double-spi-radio-raspberry-piwhen I have time, I will test the rfm69 with nrf24l01.
-
Very nice design ! I will buy a bunch of these.
I'm using a BMP180 on my raspberry now, that would be great to add an I2C port somewhere in a potential v5 :) -
I did a quick update of the PCB.
It's not perfect but it does fullfill my (selfish) needs ;)
0_1509659115842_MySensorsPiGw.kicad_pcbQQ.
-
@llegoff nice board!!! I think 🤔 I am going to build this. However just wondering if this will support rfm69hcw?
Thanks -
@gohan I have a lot c version with me :)
