Raspberry Pi2 GPIO interface for NRF24L01+
-
Cool :-)
-
Very nice, I wonder if you will be able to make an all in one "Openhab server, gateway, etc.." with the new raspberry pi 3.
-
Very nice, I wonder if you will be able to make an all in one "Openhab server, gateway, etc.." with the new raspberry pi 3.
@scooter217
Should be possible. The Mysensors gateway software on the Raspberry should run on the Zero and 3 as well. They all have the same GPIO pin layout.
The gateway software is independant of the controller. I use Domoticz, but you could use any controller on the raspi which supports serial mysensor gateway via a USB device. -
Nice, i will try it soon. Just a thought, I am right now installing a raZberry zwave. The pins that feed your board with 5 volt, in my case it is better pointing up or have it on the downside of your board, otherwise the pins will touch raZberry board and is there other places to take 5 volt from RPi because raZberry is connect directly to pin 1-10? ahh
-
Nice, i will try it soon. Just a thought, I am right now installing a raZberry zwave. The pins that feed your board with 5 volt, in my case it is better pointing up or have it on the downside of your board, otherwise the pins will touch raZberry board and is there other places to take 5 volt from RPi because raZberry is connect directly to pin 1-10? ahh
-
HI, in your list I read "IRQ 20". Don't need to be 18 instead? Thank you btw for the project. Just soldered and waiting for RPI3!
-
HI, in your list I read "IRQ 20". Don't need to be 18 instead? Thank you btw for the project. Just soldered and waiting for RPI3!
@sineverba @GertSanders sorry for quote, I did implement the IRQ on PI gateway on pin 18. Are you sure is it 20 as in description?
Of course I did print exactly your PCB and connected (with 5V with regulator and power from the 2x5V from PI) as described, but not the IRQ.
How could I test if IRQ is right and works?
Have a nice day!
