How to blink LED
-
Hi, I'm pretty new to MySensors and Arduino and I'm trying to write a simple code. I would like to toggle switch from Domoticz which will blink the LED (pin 13 on my Arduino Nano) and then Arduino will send the pin state back to Domoticz.
My Arduino is serial connected with Raspberry Pi and Domoticz. On Domoticz I have a serial MySensors Gateway.
Can u help me?
Thank you in advance. -
Hi, I'm pretty new to MySensors and Arduino and I'm trying to write a simple code. I would like to toggle switch from Domoticz which will blink the LED (pin 13 on my Arduino Nano) and then Arduino will send the pin state back to Domoticz.
My Arduino is serial connected with Raspberry Pi and Domoticz. On Domoticz I have a serial MySensors Gateway.
Can u help me?
Thank you in advance.Hi @piotr, welcome to the forum!
You should be able to use the relay example
BUT: pin 13 is used for spi communication with the radio, so you will need to use softspi instead. Doing that might be unnecessarily complicated, so it might be easier to connect a led and a resistor to some other pin instead.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login