Vera Edge Firmware
-
Hi, I just got a Vera Edge controller that was loaded with OpenWRT (for some project) and now I want to re-load the original Vera firmware for this device. Is this possible? If so, can you guys share the instructions on how to do it and where to download the firmware from?
Thanks in advance.
Regards,
Javier.
-
My Vera 3 has the stock firmware and it to seems to have OPENWRT. I found this out because it was sending out a wi-fi signal.
-
I too have a Vera Plus and the firmware used is OpenWRT. That is the base linux that the Vera controllers are built on. I don't know if theUI for the Vera Edge is the same as the Plus, but on mine if you go to Settings > Firmware in the left menu, it should check if there are any firmware updates available. It's always best to run the latest firmware available.
Suggested Topics
-
Home Security Motion Trigger Monitor
My Project • 7 Jan 2015, 08:16 • griffinsaic 8 Jan 2015, 09:42 -
API first controller with OTA support, also exposes WebOfThings APIs for sensors
Mozilla WebThings Gateway • 23 Jun 2018, 06:13 • Sathishkumar Thangavel 29 Nov 2018, 09:17 -
The Most Stable Controller and gateway, vera or another listed controller
Controllers • 24 Nov 2014, 03:15 • raditv 25 Nov 2014, 07:31 -
Actioning switch is far from instant
Vera • 14 Feb 2015, 07:08 • Dean 24 Feb 2015, 11:24 -
Vera plugin not creating devices
Vera • 4 Jan 2017, 17:05 • nicomedia 9 Jan 2017, 18:19 -
Using an UNO for Sensor With Negative Results
Troubleshooting • 23 Oct 2014, 14:48 • Adam Mikolajczyk 29 Nov 2014, 10:39 -
Sketch presentation / Vera inclusion
Development • 3 Aug 2016, 18:43 • ejtbpublic 5 Aug 2016, 18:18 -
I would like to graph my sensors output
General Discussion • 5 Jul 2015, 13:13 • 5546dug 17 Jul 2015, 13:44
