Vera Edge Firmware
-
Hi, I just got a Vera Edge controller that was loaded with OpenWRT (for some project) and now I want to re-load the original Vera firmware for this device. Is this possible? If so, can you guys share the instructions on how to do it and where to download the firmware from?
Thanks in advance.
Regards,
Javier.
-
My Vera 3 has the stock firmware and it to seems to have OPENWRT. I found this out because it was sending out a wi-fi signal.
-
I too have a Vera Plus and the firmware used is OpenWRT. That is the base linux that the Vera controllers are built on. I don't know if theUI for the Vera Edge is the same as the Plus, but on mine if you go to Settings > Firmware in the left menu, it should check if there are any firmware updates available. It's always best to run the latest firmware available.
Suggested Topics
-
Actioning switch is far from instant
Vera • 14 Feb 2015, 07:08 • Dean 24 Feb 2015, 11:24 -
3 Way Switch with Relay Sensor
Vera • 28 Sept 2014, 16:22 • rafael.brasilia 24 Oct 2019, 13:18 -
Gateway not working on VeraLite + UI6 - No Serial Port configuration available
Vera • 22 Feb 2015, 04:23 • cdrum 28 Feb 2015, 01:17 -
Mysensors, Vera and UI7
Vera • 15 Feb 2015, 02:20 • Dean 24 Feb 2015, 08:48 -
Method to reveal sketch inside node or g/w
General Discussion • 19 Oct 2015, 01:36 • 5546dug 19 Oct 2015, 19:22 -
Zwave Temp & Humidity?
General Discussion • 13 Nov 2017, 00:01 • Nelson Nico 13 Nov 2017, 16:49 -
The Most Stable Controller and gateway, vera or another listed controller
Controllers • 24 Nov 2014, 03:15 • raditv 25 Nov 2014, 07:31
