Welcome to the club!
Regarding radio's: The RFM69's with a C in the type have a smaller form factor (which is pin compatible with the predecessor RFM12B). The the 'W' and "HW' versions are larger in size and have more programmable pins (which MySensors does not use) but have exactly the same functionality within MyS.
All the footprints on the boards available in OpenHardware.io are for the 'W' and 'HW' versions so I'd go with one of these.
The 'W' uses way less power than the 'HW' which would be good the for the battery life of your nodes. Sensors powered by the grid can be 'HW', but usually, in the house a 'W' delivers enough TX power to get the message across. It might be a good idea to make your gateway with a 'HW'.
Hope this gets you a bit further. Good luck and show us your results!
@acb
Hi @acb and others, regarding "Do you know if there is a version of this board that is pad-compatible with the C-versions of these HopeRF RFM69s before I go searching? (Since I believe the C-versions are also pad-compatible with the RFM95sā¦)" - did you find any alternative?
I'm in the same boat looking for an adapter from NRF24 to the footprint of RFM69*C = RFM95/96.
Thanks, Joost
@MiKa
Hi.
oki, in case i'll add some explanation.. I'll be busy for this week but you can simply use the serial gw example from MySensors for getting started, this should work. I didn't need to create a special board in arduino for this board, so if you're using it, you'll need to install&use the mattairtech SAMD21 board definition for the pin mapping.
https://github.com/mattairtech/ArduinoCore-samd