Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

request wiring and program of 8 channel relay

Reza last edited by

hi
I have request wiring and program of 8 channel relay
Reply Quote 0
1 Reply Last reply
hek Admin last edited by

http://www.mysensors.org/build/irrigation
Reply Quote 0
1 Reply Last reply
Reza last edited by @hek

@hek hi dear hek . can I use this for light ? 8 channel light? without use of lcd and..... . just one nrf and one arduino and one 8 channel relay ?
Reply Quote 0
1 Reply Last reply

3
Posts

1463
Views

Log in to reply

Suggested Topics

Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • • petewill

90

7
Votes

90
Posts

73900
Views

Hello everyone, Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help. I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits. Any insights or guidance would be immensely appreciated. Thank you so much in advance!
ESP32 Wired (no WiFi)
Feature Requests • • Marcin

3

0
Votes

3
Posts

29
Views

Nice work there! Thank you for sharing your success, I am sure there will be others who have an interest in this type of set up.
Water leak sensor
Feature Requests • • golferjack

3

0
Votes

3
Posts

492
Views

@kimot thanks this video did help me actually
"ZHNetwork" a esp-now based mesh network for ESP8266/ESP32 hardware
Feature Requests • • graffiti

1

1
Votes

1
Posts

10
Views

No one has replied
Raspberry MQTT GW over TLS with rfm69
Feature Requests • • Tico

4

0
Votes

4
Posts

17
Views

Hi There, I had a quick look, and this looks focused on SP8266. I have myself contributed to this: New TLS implementation #1520 . I don't think this will apply for RaspberryPI MQTT GW. Thanks and regards, Eric.
debug serial gateway (homeassistant raspberry py 4)
Feature Requests • • Branther

13

0
Votes

13
Posts

67
Views

Just for reference, as this solution was no yet mentioned: You could also use a second UART on your controller or a software serial for debuging with the following defines: #define MY_SERIALDEVICE Serial // Interface for controller connection #define MY_DEBUGDEVICE Serial1 // Interface for debug output Regards, Edi

128
Online

11.5k
Users

11.1k
Topics

112.7k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1