Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

request wiring and program of 8 channel relay

Reza last edited by

hi
I have request wiring and program of 8 channel relay
Reply Quote 0
1 Reply Last reply
hek Admin last edited by

http://www.mysensors.org/build/irrigation
Reply Quote 0
1 Reply Last reply
Reza last edited by @hek

@hek hi dear hek . can I use this for light ? 8 channel light? without use of lcd and..... . just one nrf and one arduino and one 8 channel relay ?
Reply Quote 0
1 Reply Last reply

3
Posts

1463
Views

Log in to reply

Suggested Topics

Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • • petewill

90

7
Votes

90
Posts

73902
Views

Hello everyone, Firstly, I apologize for reviving such an old thread, but I find myself in a unique situation and was hoping some of you might be able to help. I hope everyone's doing well. I have a specific inquiry that I couldn't find a recent solution for. Does anyone here know of a tool to generate "fake" Dooya remote (DC90) RF codes for curtains? I've acquired a few motors without controllers and am trying to integrate them with Home Assistant and Bradlink RF remote. Specifically, I'm searching for a way to generate codes for the Up, Down, Stop, and the "Set" button functions to configure curtain limits. Any insights or guidance would be immensely appreciated. Thank you so much in advance!
ESP32 with builtin Ethernet as Gateway - f.e. WT32-ETH01
Feature Requests • • gryzli133

2

0
Votes

2
Posts

17
Views

Yes, this is a good idea. but not with an ethernet switch/hub, only an ethernet crossover cable. ?? https://copperhilltech.com/wt32-eth01-serial-to-ethernet-module-based-on-esp32-for-iot-applications/
ESP32 Wired (no WiFi)
Feature Requests • • Marcin

4

0
Votes

4
Posts

37
Views

It seems that using an Ethernet PHY (like LAN8720) with the ESP32 in a MySensors setup requires a bit of extra configuration, including initializing the PHY using the ETH.h library and disabling the default Wi-Fi initialization. Interestingly, this setup allows for dual IP addresses, with one for the Ethernet connection and another for Wi-Fi, which can be useful in certain applications.
is there a solution for a relay with button that also works offline?
Feature Requests • • Branther

7

0
Votes

7
Posts

56
Views

super, once again a few super links, thanks for that i will go for the easy way. this sketch by boots33 works perfectly. But before that i will try to understand and learn the steps. thanks again branther
"ZHNetwork" a esp-now based mesh network for ESP8266/ESP32 hardware
Feature Requests • • graffiti

1

1
Votes

1
Posts

13
Views

No one has replied
Raspberry MQTT GW over TLS with rfm69
Feature Requests • • Tico

4

0
Votes

4
Posts

18
Views

Hi There, I had a quick look, and this looks focused on SP8266. I have myself contributed to this: New TLS implementation #1520 . I don't think this will apply for RaspberryPI MQTT GW. Thanks and regards, Eric.

16
Online

11.7k
Users

11.2k
Topics

113.0k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1