water level sketch info
-
On the Build section of my sensors under moisture, there contains a sketch for soil dampness, but I wish to use the water level sensor, for a sump pump back up.
I noticed it has an analog output and the soil sketch is for digital o/p.
Is there a sketch I could use with my setup to use as an alarm/level reporting to my serial gw and verlite controller.
-
-
I'm planning on setting up a similar setup to top up a header tank for toilet water from a large tank. I have a couple of floats and a distance sensor.
My initial idea was to use the distance sensor to trigger pump but I now think I'm going to use 1 float to trigger the pump when the header thank is low and the 2nd float will be at the bottom the large tank to stop the pump running if there is no water left. I will use the distance sensor to update a display inside the house to show how much water is in the storage tank.
Suggested Topics
-
Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • 24 Mar 2014, 13:27 • petewill 12 Aug 2023, 16:39 -
ESP32 Wired (no WiFi)
Feature Requests • 15 Nov 2024, 10:39 • Marcin 20 Nov 2024, 09:13 -
Water leak sensor
Feature Requests • 12 May 2019, 14:23 • golferjack 5 May 2022, 16:51 -
"ZHNetwork" a esp-now based mesh network for ESP8266/ESP32 hardware
Feature Requests • 17 Mar 2023, 07:25 • graffiti 17 Mar 2023, 07:25 -
is there a solution for a relay with button that also works offline?
Feature Requests • 31 Mar 2023, 16:04 • Branther 4 Apr 2023, 11:37 -
ESP32 with builtin Ethernet as Gateway - f.e. WT32-ETH01
Feature Requests • 15 Mar 2023, 15:01 • gryzli133 15 Mar 2023, 21:25