OTA preflash validation
-
I think it's a good idea to implement OTA "pre flash" validation. There should a possibility to define some HARDWARE_ID into sketch, modify OTA message to tell node "these new sketch is for XYZ HARDWARE_ID" and add some predefined function (as validate_OTA()) to block flashing if code is NOT for these hardware.
Accidentally I've flashed node mounted in a field and very well water protected with a wrong HEX. Dissembling module in "the middle of field", cleaning contacts from protecting grease, flashing it and protecting again was VERY painful......
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login