@pjr that was it. I've disabled it due to 433 link and the noise which was generating and forgot about it. Thanks all for help.

I've got also 433 RFlink attached to the same domoticz. Most of the devices are fantoms on that RF433 link.
This is also why I want to move to Mysensors and NRF24 modules.
I'll try tomorrow change my nodes to use a S_HUM and V_HUM.

Thanks for the welcome :)
Yep it did send data. If you look closer at the V_LEVEL you see 8. When I see changes on the node serial monitor and refresh domoticz it the V_LEVEL reflects the changes. So looks like the data are sent and parsed by GW and Domoticz.

Hi All,

I'm compleatly new to mysensors however I've read a lot about this. Now decided to create my own mysensors network with domoticz and attached ethernet GW (on raspberrypi) using NRF24 modules.
I've got a succesful GW and configuration in domoticz and I've created my own first node with simple soil moisture sensor.
Now I see the node in the domoticz gui and I see its detected correctly, passing data:

Now all looks to be good. Domoticz is receiving data presentation of the node is also ok but domoticz is not presenting device which I can add. Actually I don't see any device from Mysensor GW (or Mysensors GW in the device list).

Is there anything which I'm doing wrong? I think this is a simple mistake but I've spent almost 4h figuring out that my radio was badly connected so I'm out of ideas. Any suggestion would be welcome.