Topics created by boanjo

@Yveaux Thanks! I've had one of the temp sensors out for two seasons and i haven't noticed any brittle tendecies. The prinouts are covered in a few layers of sparypaint so the colors still look great (as i imagine they wouldn't if not painted). But printing in ABS is of course the safest route to take.

Looking for any information about these problems. I had a network failure and the garage door opener Chamberlain B970 stopped working. I already found and fixed the problem, but I really lost contact with the remote control. Your solutions are perfect for me. Thank you! P.S. I know it's an old topic, but I wanted to thank everyone involved. I've been looking for the right information for 2 hours and didn't expect to find it here.

Just a follow-up 2 years later... Still no water incidents and the simple watersensor still looks surprisingly good! A very satisfying feeling for the third year in a row to just fill the bucket with water and plug it in and it just works The biggest problem now is that it's become harder to argue with the kids that we need to get rid of the spruce tree as it loses very little needles...

@m26872: on my side I had no trouble with nrf. maybe lucky. but you are right because I don't use common stepup, nor eval boards or I make it for test. But, there are lot of cool low noise stepup. I have not tested this, and I am very curious, I don't know if nrf/rfm range would be the same at 1.9v vs 3.3v ? btw, for range, I prefer to use rfm69 for my setup, so consumption is not the same! (my dream would be to use cc1310 but have no time to invest, I have not much time actually to play with my devices...) But I see what you mean, simplicity too, I totally agree