@tbowmo said in Sensebender Gateway RFM69HW Decoupling Capacitor: @nalith the sensebender gateway does include both 10uF and 100nF decoupling capacitors on the board, near the radio. I haven't used the GW with rfm69 that much though, so I have no experience with that radio. Great, thanks for the feedback!

@zboblamont said in SensorDoor + Backup Send: would this not report either correct state short of inhuman speed? I guess it would, but there's always the chance of missing a message, so a regular status update could help there.

@electrik said in NodeManager: Motion/Door (Interrupt) Sensor stopping DHT22 from reading value after a while: How did you wire the dht22? I had problems with it when I didn't use a pull up resistor in the past The breakout board I'm using supposedly has one integrated, will verify later this week as I'm out of town. The stage thing is if I disable the interrupt sensors (Prevent them from triggering) then the DHT does not stop reporting in.