Thanks again for your immediate advice. It should be OK now.

Hi, I missed to notice that, it works as long as the Gateway is ON, when I turn off the Gateway it stops receiving the data. I assumed that your example "Node2Node" code will work with out a Gateway in between. Please advice.

Hai jkandasa, It works fine, thank you so much for your examples and it cleared lot my doubts. Thanks again, you have given me good start.

Thank you so much and very kind of you. I will try this.

@jkandasa Hi, thank you, I am a newbie, please advice what are the changes to be done to use Node2Node, to receive data from a sender and display on a LCD or OLED please. I am finding difficult only on the Receiver side, please help.
With Great Regards,

Hi friends, in the above "The Radio Communication" topic I see these lines "You can also send messages directly between two nodes in the network without transiting through the gateway. For example, your outside temperature sensor can send its data directly to another sensor in your kitchen with an attached display."
This is what I am struggling to achieve , please help me with an Example Sketch for both sender and receiver for the above setup and it will be a great start for me to explore the excellent features of MySensors IoT.

@mfalkvidd Thank you for your immediate solution. I will try it now.

I am 74 years old retired Telecom Engineer and new to MySensors forum. I like the MySensors Battery node for Soil Monitoring and using it with ESP8266 WiFi gateway. I also want to have a Simple setup just One Transmitter and One Receiver without any Gateway to monitor Soil Moisture (and Node's Battery) of my Green House. Any pointer will be greatly appreciated.