I made this command does nothing fortunately still does not work : ( ( (

Please can you help me step by step how you did it

whether in the / dev file must be named ttyMySensorsGeteway ? if so how it developed and what it should contain

whether in the / dev file must be named ttyMySensorsGeteway ? if so how it developed and what it should contain

Hi I am a beginner
If I have something that's ok , I plugged in humidity and temperature sensor , and for what I have in front of ./PiGatewaySerial enter sudo ? ,
how to make the data visible in Domoticz please help

@revoltec112 said:

http: // forum.mysensors.org/topic/1151/tutorial-raspberry-pi-nrf24l01-direct-connection

here is the link to connect and for testing can be seen on the RPI data transmitted from the remote sensor but the question is how to do it domoticz read ???

hello I know but I have tried through the gate USB and also was not working , help me as you can, how you want your file ttyMySensorsGateway , I like it open in the nano this file is empty or perhaps me someone some idea how this is supposed to look , please , I really already sit on it week and nothing

domoticz not read with raspberry or I do not know how to read temperature and humidity

Hello do not speak English and this is my first post :) PLS HELP MY

I am a beginner in the subject raspberry want to read the temperature of the Arduino Nano mini through nRF2401 ( scratch is from github standard temperature reading ), the second nrf24 is attached directly to the RPI via GPIO ports , according to the
http://forum.mysensors.org/topic/1151/tutorial-raspberry-pi-nrf24l01-direct-connection
performing the test ./PiGatewaySerial and including the Arduino Mini can be seen on the test that the data is sent but do not see anything in domoticz please help what I'm doing wrong really been a long time over this sit

pi@mysensors ~/Raspberry $ sudo ./PiGatewaySerial
Starting PiGatewaySerial...
Protocol version - 1.4
Created PTY '/dev/pts/2'
Gateway tty: /dev/ttyMySensorsGateway
================ SPI Configuration ================
CSN Pin = CE0 (PI Hardware Driven)
CE Pin = Custom GPIO22
Clock Speed = 8 Mhz
================ NRF Configuration ================
STATUS = 0x02 RX_DR=0 TX_DS=0 MAX_RT=0 RX_P_NO=1 TX_FULL=0
RX_ADDR_P0-1 = 0xa8a8e1fc00 0xa8a8e1fc00
RX_ADDR_P2-5 = 0xff 0xc4 0xc5 0xc6
TX_ADDR = 0xe7e7e7e7e7
RX_PW_P0-6 = 0x20 0x20 0x20 0x00 0x00 0x00
EN_AA = 0x3b
EN_RXADDR = 0x07
RF_CH = 0x4c
RF_SETUP = 0x23
CONFIG = 0x0e
DYNPD/FEATURE = 0x3f 0x06
Data Rate = 250KBPS
Model = nRF24L01+
CRC Length = 16 bits
PA Power = PA_LOW
read: 1-1-0 s=255,c=0,t=17,pt=0,l=3:1.5
read: 1-1-0 s=255,c=3,t=6,pt=1,l=1:0
read: 1-1-0 s=255,c=3,t=11,pt=0,l=18:Temperature Sensor