@manutremo thankyou very much for a good answer! I will try it out tonight. This information should be easier to find in some faq or am i the only one who made this mistake ? :)

Hi! this is my first thread and im kind of a newbie at mysensors. Ive made alot using arduinos before but this time i cannot make it work.
i recently bought a nRF24L01+ pa (with antenna) and got it working with nocemcu from what i can see.
I use the handy adapter boards ( http://www.addicore.com/nRF24L01-Adapter-p/123.htm ) and they seem to work good. i checked the voltage and its 3 volts to the module. ive also used a 10uf capacitor on vcc and ground soldered on.

my problem is to get a node working with an arduino pro micro and i accidently bought the nRF24L01(without +) in 10packs and i cannot find the link for slowing down the rate to 1mbps to get them working.

so my question:

1. is it possible to use arduino pro micro?
2. how should i change settings to get the modules without + working with my +module as gateway.
   ive tried different power supplys and with or without the adapter board.

the output for my sensors is typical

811645 TSF:MSG:SEND,255-255-255-255,s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=OK:
813647 !TSM:FPAR:NO REPLY
813647 TSM:FPAR

i use domoticz as controller.
im sorry if this is a common question. ive looked around trying to find a good thread.
i love the creativity and i look forward to building!
/Tobias