Hi everyone,

i'm close to finalizing the 1.1 version of the board (i hope the final version), and in the same time i have made an arduino pro mini version of the board.

For the pro mini version, should i create another Openhardware project, or should i put it here, in the already existing project?

Thanks

Thanks for answers
i think i should find some m2 motherboard spacers and screws in the bottom of a cardboard box, and if i need a box, double sided tape or hot glue ^^

@GertSanders

well, 2mm works fine (no routing pb), but i keep in mind the double sided tape idea

Thanks for the tips ^^

Hi everyone ^^

just a little question about PCB support…

i'm at the end of a project, but i'm a little stuck on the fixation part of the board…

in the first version, i have just putt two hole with pretty random diameter, but for the actual version (i hope final version), i want to chose the most smaller diameter, but with possibility of attachement in a plastic box

so two questions :
-what kind of fixation do you usually use, and where can i find them?
-what diameter could i use on the pcb for the fixation? (2mm start to be tricky for routing with just two hole on the board, 4mm was… maybe not impossible, but really close to that!)

Thanks

Hi everyone,

i'm close to finalizing the 1.1 version of the board (i hope the final version), and in the same time i have made an arduino pro mini version of the board.

For the pro mini version, should i create another Openhardware project, or should i put it here, in the already existing project?

Thanks