Modifying a Raspberry Pi dislay
-
Hi All,
I got this 5" raspberry pi display, XPT2046 Touch Controller. Currently it has a hardware backlight on/off switch and i'm looking to change that to be able to turn on and off the backlight using a script from raspberry pi.
I am looking for an always on gate that i can control through a pin. My initial thought was to place a tranzistor, but not sure if that will work. Any other ideas ? how can i achieve this really simple and easy ?
Regards
Adrian. -
@ady_e_n Presumably a low current DPDT switch.
Since I have them anyway I'd be using a latching DPDT signal relay fired by two logic level mosfets controlled by two pins, hence emulating the switch itself with no running current. The relays I have are NEC EE2-3TNU around 7mm thick and 9mm tall, 5v version should be available if that is your logic voltage level.
If space permits you could hot glue the relay to the board on it's side with the mosfets/resistors/3 pin control mounted onto it's base, hard wired to the original switch pads.
;)
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login