NRF5 Receive Challenges

[nagelc]

Hi All,
I have not been able to connect my NRF52832 nodes to the gateway when using the MySensors development branch. I used the MySensors PassiveNode sketch to run some tests. It is a very simple sketch that sends random temperature readings. I tried the basic passive node, commenting out passive node, and disabling the uplink check on using both branches. Results:

So the node appears to have some difficulty receiving messages from the gateway and has different issues between Master and Development branches. I have done some diffs of likely files but nothing jumps out at me as a suspicious difference between Master and Development.
I'm using MY_RADIO_NRF5_ESB and assigning a static node number.
I have to define MY_NRF5_ESB_MODE (NRF5_250KBPS) when using the Development Branch because my network is 250KBPS. I know this is deprecated. Could the low data rate be causing the receive issues?

Can anyone point me to next steps for troubleshooting?

[mfalkvidd]

@nagelc maybe https://github.com/mysensors/MySensors/pull/1455#issuecomment-778836586 is related?

And https://github.com/mysensors/MySensors/pull/1473

[nagelc]

Thanks @mfalkvidd I'll check these out.
I'm seeing an upgrade to 1MBS in my future, but I have a lot on nodes that would need to be updated. I'll probably put that off as long as I can : )

[nagelc]

Ah ha. It worked. Updated the 250KBS callouts per the pull request.
NRF5 communicates normally.

Thanks!

[mfalkvidd]

Nice work @nagelc, thanks for reporting back.