No devices in Domoticz

[kopite]

Has anyone had success with Domoticz?
I have added a serial usb gateway and pulse sensor but no devices show up?
I can see in the log the following lines
2015-04-30 21:47:31.646 MySensors: Node: 86, Sketch Name: Energy Meter
2015-04-30 21:47:31.654 MySensors: Node: 86, Sketch Version: 1.0

but i cannot see the device....anyone know how to resolve

[AWI]

@kopite Are you sure the gateway is receiving "data" messages from the pulse sensor, other than the "presence" messages your see in the Domoticz log?

[andriej]

Domoticz has something wrong with water/pulse meters.
It does not send it's VAR (even if it's 0) for a long time.
Try to reset it a lot and assing node ID by yourself.

[hautomate]

When you go to Setup > Devices and click All Devices does it show?

[kopite]

@AWI - How do i check this?
@Andriej - How do i Assess the node ID?
@hautomate - Only my RPi internals show up in devices

[AWI]

@kopite Use the Serial monitor on the pulse meter Arduino and check if any VAR messages are sent with status ok. (debug on = default). If so then you know that at least the Gateway (and therefore Domoticz) is receiving information.
If so and the Pulse meter data is not receive you could try a Temp or Light sensor to test if that works.

Happy debugging :)