No devices in Domoticz



  • Has anyone had success with Domoticz?
    I have added a serial usb gateway and pulse sensor but no devices show up?
    I can see in the log the following lines
    2015-04-30 21:47:31.646 MySensors: Node: 86, Sketch Name: Energy Meter
    2015-04-30 21:47:31.654 MySensors: Node: 86, Sketch Version: 1.0

    but i cannot see the device....anyone know how to resolve


  • Hero Member

    @kopite Are you sure the gateway is receiving "data" messages from the pulse sensor, other than the "presence" messages your see in the Domoticz log?



  • Domoticz has something wrong with water/pulse meters.
    It does not send it's VAR (even if it's 0) for a long time.
    Try to reset it a lot and assing node ID by yourself.



  • When you go to Setup > Devices and click All Devices does it show?



  • @AWI - How do i check this?
    @Andriej - How do i Assess the node ID?
    @hautomate - Only my RPi internals show up in devices


  • Hero Member

    @kopite Use the Serial monitor on the pulse meter Arduino and check if any VAR messages are sent with status ok. (debug on = default). If so then you know that at least the Gateway (and therefore Domoticz) is receiving information.
    If so and the Pulse meter data is not receive you could try a Temp or Light sensor to test if that works.

    Happy debugging 🙂


Log in to reply
 

Suggested Topics

  • 5
  • 4
  • 5
  • 1
  • 3
  • 5

0
Online

11.2k
Users

11.1k
Topics

112.5k
Posts