MQTT Sketch will not move to my Arduino Uno
-
I am using the codebender chrome app, but i have also tried in the arduino 1.6.4 IDE and get the same result. I can connect to my Arduino. I can move sketches to my arduino (I have tried on both an official unoR3 and a knockoff with same result). However when I use the latest MQTTGateway sketch on codebender or from MySensors I get an error saying cannot connect to my arduino. Since I can connect for other sketches I feel like this error is hiding the real issue. Has anybody else had this problem?
Sketch says this at the top which I assume is a version #
Created by Daniel Wiegert <daniel.wiegert@gmail.com> Based on MySensors Ethernet Gateway by Henrik Ekblad <henrik.ekblad@gmail.com> http://www.mysensors.org" -
Arduino Ethernet W5100 network expansion module - I bought from china: http://www.aliexpress.com/item/For-Arduino-W5100-Ethernet-module-network-expansion-board-SD-card-expansion-mega-2560-1280-328-UNR/32215690927.html
You think that might be causing an issue? Must that even be connected to load a sketch? I will remove it and try again later today.
-
OK Thanks. I was just playing around with this last night and had not wired up the radio yet. So I actually did not enable SOFTSPI in the library. Maybe that is the issue? I will slow down and follow all the steps. Still seems like a strange error. Thanks for your help.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login