RF24_PA_LEVEL and options
-
I have been looking in MyConfig.h for the different levels to set for RF24_PA_LEVEL and RF24_PA_LEVEL_GW, but could not find it in the documentation. Only RF24_PA_MAX and RF24_PA_LOW was shown as options.
In the forum I found that all these options can be used - RF24_PA_MIN, RF24_PA_LOW, RF24_PA_HIGH or RF24_PA_MAX.
I suggest that these options are added as remarks in MyConfig.h.
-
Making the valid values available in MyConfig.h would be nice from a user standpoint. They would need to be kept in sync with the definition in RF24.h though, so the comments in MyConfig.h reflect what is actually implemented.
-
I was just yesterday testing a system I'm going to install on the summer cottage, and noticed that I get hardly 2 meters range. Then I noticed the sketch has 'RF24_PA_LOW' by default.
Is it OK/safe etc. to use the highest PA level for the PCB antenna versions of nRF24 ?
Suggested Topics
-
Controlling Blinds.com RF Dooya Motors with Arduino and Vera
My Project • 24 Mar 2014, 13:27 • petewill 12 Aug 2023, 16:39 -
ESP32 with builtin Ethernet as Gateway - f.e. WT32-ETH01
Feature Requests • 15 Mar 2023, 15:01 • gryzli133 15 Mar 2023, 21:25 -
Raspberry MQTT GW over TLS with rfm69
Feature Requests • 14 Sept 2022, 15:11 • Tico 16 Sept 2022, 07:23 -
is there a solution for a relay with button that also works offline?
Feature Requests • 31 Mar 2023, 16:04 • Branther 4 Apr 2023, 11:37 -
ota-configuration
Feature Requests • 8 Mar 2023, 09:28 • pbw 8 Mar 2023, 09:28 -
PJON on RS485
Feature Requests • 11 Apr 2022, 06:58 • hypnosiss 9 Mar 2025, 07:57
