Sensebender Micro Case

[Ironbar]

Here is my take on a case for the Sensebender Micro. I left space at the top so it could be adapted for a proxy sensor, etc. These are for my refrigerator and freezer so they don't need to hang.

They still need a little sanding...

Here is my attic sensor w/ a hanging tab:

[Dwalt]

@Ironbar
Nice design! Can you post the files or link to a depository?

[mfalkvidd]

Cool. I like the stacking of the batteries. Are you using two singe-battery holders in series or were did you find that variant of holder?
Edit: series, not parallel. Words are confusing

[Ironbar]

@Dwalt

Sure. Here it is on thingiverse:

http://www.thingiverse.com/thing:1410004

@mfalkvidd

The battery holder is a single holder with two AA batteries. The batteries are ran in series. To be honest, I can't remember where I bought the holders but I like them because they clip on like a 9 volt so you can easily disconnect the battery holder from your project.