Humidity/Temp Program, Serial Monitor Issues

[NotYetRated]

Hello,

Created a device using the humidity sensor code (http://mysensors.org/build/humidity).

All appears to be working fine(aside from some wacky temps off by about 10 degrees F), except when I go in to serial monitor to see the units output, all I get is the below gibberish.

’ý
ˇPž+šŒ21’úÙUٝS,;›’j˜ôŽØ"éUٝS)$º«)µÎq¤ÛI¶RSs%[º»q1qÂüÙ÷šeÎ|ÌÅÉûI.þÀ!S)Z<ŸÖT›}rùÿº»@ٝSr‰z ü›5}ráÿ™PµâÂêÙ$þp ü¦¬µqš\ÿº»DyÍSsµÿ«‚üšeÎ|‘º€ü

Any ideas?

[hari]

make sure to select he proper baud rate in the serial monitor.

[NotYetRated]

@hari DOH, that was it. Thanks!