Got 3 up just using the built in temp/humidity, making sure all looks ok. Will slowly add motion.
Any suggested motion sensor for these guys?
Is there support for an RGBW LED strip in Domoticz?
Similar to this, which is in Vera: http://forum.mysensors.org/topic/1626/5-channel-rgbww-led-dimmer-with-rotary-encoder/3
You can do this right in the sketch. Upload the standard sketch, check your readings, find your delta, and then modify your sketch to accommodate.
Or, use the offset feature in Domoticz, if that is the controller you are using.
And if you really need an accurate measurement, don't forget to check your readings at multiple setpoints. The math for calculating your offset would then become a little more difficult, but any basic calc knowledge and you've got it.
A second for these. I purchased from ebay about a year ago, more expensive but same unit. Working in 4 cameras.
Hello, I am looking for some ideas of what others are using for power/sensor connections to their boxes. I have some boxes with long external DHT, Dallas, PIR sensors. Looking for good plug connections, male and female, to use for quick and easy connections to my boxes. Currently I just run the wires in and solder them or screw terminal. Looking for plugs or something which may be a little neater. How are others using?
I have not had problems with enclosures per se, but I have seen temperature differentials due to locations exposed to direct sunlight and up against thermal masses such as a external walls or internal walls with enclosed heating ducts or hot water piping. I have four sensebenders in vented enclosures mounted on interior walls and have no problem with their accuracy. They are also loosely mounted inside their enclosures which may help them avoiding picking up heat from the walls. Overall, they seem much more consistent and accurate than the several DHT or Dallas sensors I have in my system.
Thanks for the reply, perhaps my issue stems from my enclosures being mostly sealed. No venting what so ever. I did a quick test of a few of my sensors, opening the boxes and letting them sit in open air and the differentials came down substantially.
Will look in to adding some venting!