Adding devices - how?

[NotTooTechy]

I have just installed Domoticz and added hardware as a DHT sensor and using the serial gateway. I have read the docs PDF, but can't find anything on adding details to make it work. In the Devices page it shows "DHT-sensor" and a blue button with "Settings" but cannot find where or what to do to make it work.

Could someone point me at some instruction. Thanks

[flopp]

In Device->All devices you should see your MySensors Node. Can you see that?

What time does it says when it was Last Seen?

[sundberg84]

Also remember that the device isnt visible in "devices" until the node has sent its first value. Its not enough with a presentation (except for switches).

[NotTooTechy]

Thanks, my mistake, did not have the things configured correctly. I now have three devices visible. Two are shown correctly, the first as Light (relays) and the other Temp/Humidity (DHT) but the Gateway is showing as "Temp" but I guess I can ignore that.

I will start a new thread on what I am trying to do now that the three Arduinos are all visible in Domoticz.