Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Wrong spelling in FAQ Guide

flopp last edited by flopp

Check at 2.3
https://forum.mysensors.org/topic/666/debug-faq-and-how-ask-for-help

First sentence telling you to add a Cap between GRN/VCC, GRN=green.
Should be GND.
"Do you have a capacitor between grn/vcc on the 3.3v radio?"
Reply Quote 0
1 Reply Last reply
mfalkvidd Mod last edited by @flopp

@flopp fixed! Thanks for noticing.
Reply Quote 1
1 Reply Last reply

2
Posts

580
Views

Log in to reply

Suggested Topics

Day 1 - Status report
Announcements • • hek

3

0
Votes

3
Posts

1519
Views

Feels much faster from here too!
MySensors Gateway Controller Failed to ACK I_FIND_PARENT Request from Node
Troubleshooting • • Eme

9

0
Votes

9
Posts

51
Views

@Eme Thank you for coming back to report how you solved your problem! Your comments will help other people. I am a big fan of Frugal Tech and I think MySensors is great for that. Alas, MySensors is not well supported anymore. Right now I'm having problems linking to the home page It's people like you and me that will keep MySensors going. Thanks for your help. OSD
Flame Sensor Not Triggering Setup
Troubleshooting • • Jordan22xx

3

0
Votes

3
Posts

11
Views

You write "...clicking is heard..." Is that a single click or a click click click ...? After getting the LOW signal, wait a period of time and if it's still low, send the message that there is a flame. Likewise for a HIGH signal. Perhaps instead of a relay, an opto-isolator?
Raspberry Pi 5: invalid GPIO 9
Troubleshooting • • igo

4

1
Votes

4
Posts

24
Views

https://github.com/mysensors/MySensors/pull/1562 switches to using libgpiod instead of the earlier interface. I have not tested it myself but it looks good.
Cannot compile sketch with STM32F1 BluePill board
Troubleshooting • • tnick

5

0
Votes

5
Posts

24
Views

@tnick I know this is an old post, but if it helps you - I've created support for STM32 based on latest STM32duino here. It's currently made to be backward compatible for the existing STM32F1 support, which is what you are struggling. But with a small change you can use the new STM32 HAL support. Let me know if you are interested to give it a try. The longer term plan is to remove the existing (old) STM32F1 support in favor of the new and more general STM32 support. (If @mfalkvidd agrees ;-))
JSN SR04T - Temperature Influencing Readings
Troubleshooting • ultrasonic water level tank • • Timbergetter

34

1
Votes

34
Posts

1377
Views

I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature. @zboblamont have you been finally been able to find a solution?

24
Online

11.7k
Users

11.2k
Topics

113.0k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1