Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you may not be able to execute some actions.

Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).

Sensos in the Serial Gateway 2.0

Tagore.PDE last edited by

Hi all, i see in the 2.0 version can add sensors to the gateway, anyone have a sample how to add for example a DHT11?

Regards.
Reply Quote 0
1 Reply Last reply
hek Admin last edited by

Quite a few of the old examples have been moved to a new repository (converted to 2.0) because of their to external dependency requirement.

You can find the DHT (humidity) example there as well.

https://github.com/mysensors/MySensorsArduinoExamples
Reply Quote 1
1 Reply Last reply

2
Posts

890
Views

Log in to reply

Suggested Topics

Day 1 - Status report
Announcements • • hek

3

0
Votes

3
Posts

1519
Views

Feels much faster from here too!
constant PIR false alerts
Troubleshooting • • mvader

12

0
Votes

12
Posts

3722
Views

@mvader Turn the time delay adjustment preset on your PIR module to the minimum.. Now try it.. You will not get a continuous output..Also, prepare the circuit using a long wire from the back to the sensor of your module.
JSN SR04T - Temperature Influencing Readings
Troubleshooting • ultrasonic water level tank • • Timbergetter

34

1
Votes

34
Posts

1377
Views

I'm having the same / a simular issue of temperature related readings, but at a different temperature level (for me it must be > 14 degree). I massure the dew point as well (temperature = orange, dew point = yellow). It looks to be more related to water in the air than only to temperature. @zboblamont have you been finally been able to find a solution?
HW-488 infrared sensor not detecting properly
Troubleshooting • • jaydenlord

2

0
Votes

2
Posts

11
Views

@jaydenlord Probably you do. If you leave the EN floating, electrical noise could cause it to enable or disable randomly. Some enable pin require a HIGH, some LOW. Connect it to VCC to see if it works more consistently. If it doesn't detect, connect it to GND. If one of these works, then the part wasn't designed to be in a default state of enable. Let us know your results (I found this video OSD
Raspberry Pi 5: invalid GPIO 9
Troubleshooting • • igo

4

1
Votes

4
Posts

24
Views

https://github.com/mysensors/MySensors/pull/1562 switches to using libgpiod instead of the earlier interface. I have not tested it myself but it looks good.
What are the pin numbers for D3, D4, ...
Troubleshooting • digitalwrite digital io pin numbers • • Bens

8

0
Votes

8
Posts

1828
Views

@Vuinne-Ryvmar You seem to be confused about what this forum is. Maybe you just ended up here on a random Google search? But in our case on an Arduino, D3 is literally the name for one of the metal legs coming off of the little controller, and we call it a pin sometimes. @tbowmo was looking for how to send the command to turn the power on or off to that part of the board, not a code to enable connecting up a controller to their phone. I see that a D3 game controller is a thing, but I doubt you will have any luck getting help with that here. It's not what this site is about. This is what we work with:

29
Online

11.6k
Users

11.2k
Topics

113.0k
Posts

Copyright 2019 TBD | Forum Guidelines | Privacy Policy | Terms of Service

1 / 1