RS485 communication GW - Node Problem

[hausinger]

Hello community

I want to use Mysensors in future to use it in my new house as a wired bus system.
So i tried it out today with a arduino nano and a arduino pro mini.
I downloaded the newest mysensors library in the Arduino IDE and upload the RS485 GW scatch to the nano and the rs485 PIR scetch to the arduino pro mini.
I also downloaded the MYSController App on Windows.
Than i tried to connect the 2 Arduinos to check, if it all running fine.
But in MYSController i can only see the GW.

First i was trying to use the max chips for the communication, but the GW does nothing.
So i tried to connect directly the Nano and the Pro mini, but the GW does always nothing.

The pins i used with the max chips is 8, 9, 2 on Nano and on Pro mini.
In direct connection i connected only 8 and 9. Both arduinos are on the same ground potentional.

I switched on then de debug in the node, here is the serial output:
TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
TSM:FPAR
TSP:MSG:SEND 255-255-255-255 s=255,c=3,t=7,pt=0,l=0,sg=0,ft=0,st=bc:
!TSM:FPAR:FAIL
!TSM:FAILURE
TSM:PDT

My GW Log is this:

0;255;3;0;9;Starting gateway (RSNGA-, 2.0.0)
0;255;3;0;9;TSM:INIT
0;255;3;0;9;TSM:RADIO:OK
0;255;3;0;9;TSM:GW MODE
0;255;3;0;9;TSM:READY
0;255;3;0;14;Gateway startup complete.
0;255;0;0;18;2.0.0
0;255;3;0;9;No registration required
0;255;3;0;9;Init complete, id=0, parent=0, distance=0, registration=1
0;255;3;0;5;1

Hope, somebody can help me?
Best regards

[hausinger]

I solved the issue.
Could be closed.

[hek]

What was your issue?

[hausinger]

@hek

Sorry for my Late reply.
I had an issue with the max485 (ground problem) and the declaration of the node id (was at the wrong position in the sketch).
I think, it would be better, if this is also in the examples in the ms library.
It cost me some time to find this solution for the node id. But i wasn't sure, if it was the parent or node id