RS485 Speed and different routing possible?

[stedew]

Hello someone tested a higher speed setting for the (new) RS485 communication in MS2.0.?
I think that 9600baud is really slow. That being sayed i have to admit it works like a charm.
-So when someone can confirm that this works also with long(er) lines and higher speed i would like to know.
In my setup i use on one side (GW + RPI) a ADM2483 (isolator) so that i have a galvanic separation and can play safely with the sensors. these are often near the life (electric cabinet/enclosures) on the other side (sensors /field) i use the MAX485 or an SN75HVD12DR RS485.
Second question: is it possible to send a message from one sensors to another on the same bus? Without the need to use code in the GW? to route the recaiver?
Regards,
Stefan.

[hek]

Guess you have to do some tests... increasing the speed and see when it fails

Regarding routing, the messages will be routed exactly like in a radio network. Se you have to have a gateway node in the setup to send messages between nodes.

[stedew]

haha,
I knew you gonne hijack this thread
As you answered the first question (more or less)
i was looking for a good test rig
long distance transmission line

I yust have to re-read the specs off the ADM isolator i think
So there is no possibility to route from node to node pitty.
Tnx for the answer anyway i will try the higher speed setting (57K6 or so)
Btw good write up about the RS485 setup on the home page it will defenetly speed up things (as i spend a few hours wit wrong setup)
Regards,
Stefan.