Cant connect to w5100 ethernet gateway

[rkressa]

Wired up a w5100 and radio as shows in the ethernet gateway build page. Using a generic arduino uno with the w5100 hooked up to 5v and the radio hooked up to 3.3.

Serial Monitor shows:

0;255;3;0;9;Starting gateway (RNNGA-, 2.0.0)
0;255;3;0;9;TSM:INIT
0;255;3;0;9;TSM:RADIO:OK
0;255;3;0;9;TSM:GW MODE
0;255;3;0;9;TSM:READY
IP: 10.0.0.25

I cannot see the IP address on my router device page.

Vera says: MySensors plugin : Cannot send command - communications error

Any ideas?

[TheoL]

@rkressa What happens if you type in ping 10.0.0.25 does your ethernet respond?

Also make sure that the 10.0.0.25 is in your network ip range and subnet mask

[Attiq]

https://forum.mysensors.org/topic/4680/mysensors-2-0-ethernet-gateway-atmega-w5100-restart-all-time

Downgrade your AVR core to 1.6.11, it will work.