UNO R3 + Prototyping Breadboard + W5100 Shield

[gohan]

If you remove the prototype shield everything works?

[iotearoa]

Unfortunately no, I'll check if its the clone shield is at fault and let you know

[sundberg84]

@iotearoa - I have had the exact same setup as well, default ethernet sketch and it did work.
Do you have any serial output/debug?

[iotearoa]

@sundberg84 it was blank. I'll start with just simply the ethernet shield and use the DhcpChatServer sketch to rule out it's not the shield then move my way to the NRF. Thanks for the rapid response. I'm testing it now.

[iotearoa]

It turns out the W5100 ethernet is working after using the sample sketch from Arduino.
Now plumbed NRF directly on the W5100 shield:

Now I'm getting this:

[gohan]

Post your code please

[sundberg84]

@iotearoa - put the capacitor as near the radio as possible, solder it directly over GND / VCC and not near the arduino.

[iotearoa]

@gohan copy pasted the one from here

https://raw.githubusercontent.com/mysensors/MySensors/master/examples/GatewayW5100/GatewayW5100.ino

thank you

[iotearoa]

@sundberg84

Hmm... no good.. I've basically moved a known working breadboard + 4.7uf from my other prototype below. I'm still getting the same error.

I'll triple check the wiring and replace all of them just in case.

[iotearoa]

Found out that my W5100 clone is having serious auto-negotiation issues with my linksys switch. I jumped it earlier like this

[iotearoa]

@sundberg84 @gohan its solved. Thanks for the help! Bad, 4.7uf, poor wiring and not to mention "a man look" on which pins I've used :)

Thanks again!

[gohan]

With all of that, no wonder it wasn't working :D
What kind of project are you running with those nodes?

[iotearoa]

@gohan

I'm measuring ambient lighting and motion sensor (Its directly using a 12v PIR ) at the moment in my room and using a

Mosquitto+Paho+MongoDB+SlamData for some analytics. I'm curious what analytics I'll get with this setup. Who knows right? :)

Then you'll notice there's an OLED. It's just simply a replacement for the serial() so I can see the debug than plugging the USB all the time.