2 systems in same location

[C.r.a.z.y.]

If i want to use 2 or more systems in the same location; sensors will be mixed? How can i ban other system to see my already working sensor? (For vera gateway)

[hek]

Select a different frequency (MyConfig.h) before compiling/uploading the new sensors/gateway.

[C.r.a.z.y.]

Thank you Hek.

#define RF24_CHANNEL 76 //RF channel for the sensor net, 0-127

If i change** 76 to 77** it will be a different freq?

#ifndef MyConfig_h
#define MyConfig_h

/***

• Configure Sensor Network
  */
  #define RF24_CHANNEL 76 //RF channel for the sensor net, 0-127
  #define RF24_DATARATE RF24_250KBPS //RF24_250KBPS for 250kbs, RF24_1MBPS for 1Mbps, or RF24_2MBPS for 2Mbps
  #define RF24_PA_LEVEL RF24_PA_MAX //Sensor PA Level == RF24_PA_MIN=-18dBm, RF24_PA_LOW=-12dBm, RF24_PA_HIGH=-6dBM, and RF24_PA_MAX=0dBm
  #define RF24_PA_LEVEL_GW RF24_PA_LOW //Gateway PA Level, defaults to Sensor net PA Level. Tune here if using an amplified nRF2401+ in your gateway.
  #define BASE_RADIO_ID ((uint64_t)0xA8A8E1FC00LL) // This is also act as base value for sensor nodeId addresses. Change this (or channel) if you have more than one sensor network.

// MySensors online examples defaults
#define DEFAULT_CE_PIN 9
#define DEFAULT_CS_PIN 10

/***

• Enable/Disable debug logging
  */
  #define DEBUG

#endif

[hek]

yes
....