💬 Ebyte nRF52832 Prototyping Board
-
-
I suppose panelizing this board together with a pure prototype board might achieve the objective I was aiming for....
-
It works. Project completed. :)
-
I recommend snipping off the DTR pin using flush cutters. Given the current configuration, it isn't going to work properly.
-
Can you please propose what type of inductors and capacitors did you use ?
A BOM will be great.Actually I am asking because I knew there is something called SRF from this topic https://devzone.nordicsemi.com/question/171472/filter-inductor-requirement-for-nrf52832-in-dcdc-mode/
Thanks.
-
Can you please propose what type of inductors and capacitors did you use ?
A BOM will be great.Actually I am asking because I knew there is something called SRF from this topic https://devzone.nordicsemi.com/question/171472/filter-inductor-requirement-for-nrf52832-in-dcdc-mode/
Thanks.
@ahmedadelhosni said in 💬 Ebyte nRF52832 Prototyping Board:
Can you please propose what type of inductors and capacitors did you use ?
A BOM will be great.It is exactly the same BOM as this: https://www.openhardware.io/view/471/Ebyte-nRF52832-Small-Breakout-Board#tabs-bom
-
@ahmedadelhosni said in 💬 Ebyte nRF52832 Prototyping Board:
Can you please propose what type of inductors and capacitors did you use ?
A BOM will be great.It is exactly the same BOM as this: https://www.openhardware.io/view/471/Ebyte-nRF52832-Small-Breakout-Board#tabs-bom
@NeverDie thanks
