5V boost converter smoked on first use
-
I have purchased some of the recommended 5V boost boards at https://www.ebay.com/itm/DC-DC-Boost-Converter-Module-Step-Up-Module-1-5V-to-5V-500mA-for-phone-MP4-MP3/381185956688.
As soon as I have applied approx 4VDC at the input (no load) the board my PSU has hit the current limit. No wanting to give up so easily I then tried an 18650, which produces some nice smoke.
faulty board or operator error?
-
@grumpazoid I'd say operator error if you connected the power supply incorrectly, faulty board if you connected the power supply correctly
-
It's difficult to say with so little information.
Do you have a picture of the board?
How did you wire things up exactly? Are you sure you didn't reverse polarity? Perhaps you're sot supposed to run these without a load?
-
I was wondering about the no load.
I've just carried our some further investigation . It looks like C3 that is connected between ground and 5V O/P has been shorted out with solder. I guess this would exceed the 500mA specified ;).
-
-
This post is deleted!
-
This seems that E50D might be same as CE8301, but somehow they use a smaller cap, maybe to save money, try to replace C3 with a 100uf 16V electrolyte capacitor
-
@bjacobse Thanks. In the end i removed the solder that was shorting out the capacitor and it now outputs 5V. Not sure how safe it is after the overheat
As an experiment I cut the track to take the LED out the circuit. This reduced the current from 2mA down to a few uA.
Suggested Topics
-
Over the air updates
General Discussion • 23 Mar 2014, 21:38 • ToSa 1 Mar 2015, 11:21 -
Arduino Nano Every problem
Hardware • 1 Feb 2020, 09:18 • hakha4 5 Dec 2023, 02:21 -
hlk-pm01 are to noisy for rfm69?
Hardware • 5 Aug 2023, 21:16 • Tmaster 9 Aug 2023, 16:28 -
Newbie questions
Hardware • 3 days ago • magwas 3 days ago -
Best VOC sensor for detecting a wide range of VOC's?
Hardware • 26 Oct 2023, 23:59 • NeverDie 18 Nov 2023, 01:41 -
Sensor to detect marijuana vape/smoke
Hardware • 28 days ago • Hellmark 27 days ago