RFM69 using Mysensors 2.3.2

[Highland]

Apologies if i have missed this answer somewhere. I would like to know if the 'MY_RFM69_NEW_DRIVER' definition is needed any more in Mysensors 2.3.2? I see the examples i've looked at don't show it used. What is best practice? Thanks.

[mfalkvidd]

Welcome ro the forum @Highland

MySensors supports two rfm69 drivers; the ”new” and the ”old”. They are not compatible.

So anyone with an existing rfm69 MySensors network probably wants the old driver, which is default.

Anyone startung to build a new network should use the new driver by adding the define to all sketches.

[Highland]

Thanks for the advice and the prompt reply.

[SuperNinja]

@mfalkvidd Hi, I am desperately looking for a configuration for the RFM69HCW with an ATmega328p.

• I am lost between the old library <2.0 and the new one
• the old RFM69 driver and the new one

can you give me an example configuration? or a simple Sketch node to beginning ?

[mfalkvidd]

@SuperNinja sorry, I don't know. If i knew, I would have responded in your original post.

[SuperNinja]

@mfalkvidd I'm sorry to have duplicated my request, as you were using RFM69, I thought you had a configuration already done.
HCWs (HW) are so popular that I thought someone had a working config, so I could start developing my nodes / gateway with the last libraries and current driver.

[mfalkvidd]

@SuperNinja I built a node and a gateway some years ago, but I don't remember doing anything but fullowing the instructions on the build pages.

[scalz]

answered here : https://forum.mysensors.org/topic/11404/rfm69hcw-beginning-of-a-newbie-with-atmega328p