"0" Temp and Pressure readings from BMP280
-
Please assist if possible,
I am using an Arduino UNO as well as a ESP8266 card with a BMP280 installed
I am using the following sketch to try to get familiar with this operation
SparkFun_BME280/I2C_ReadAllData.ino at master · mhaack/SparkFun_BME280 (github.com)
On the serial port I am getting a "0" reading for Temp C and "0" Pa which possibly accounts for an extremely high Altitude reading.
From my untrained eye, this looks like a calibration issue but I am probably wrong. Possibly a coding issue.
I cannot see what the issue is.
-
Hi @Merlotmaker,
If you want more reactions from members, you should provide more information.
- what for sensor do you have, because you are speaking about BMP280 and BME280
- the lib you are referring to is a specific one for the https://www.sparkfun.com/products/13676
- how did you connect your sensor to the UNO?
- did you follow this guide already? https://learn.sparkfun.com/tutorials/sparkfun-bme280-breakout-hookup-guide
2 out of 2
Suggested Topics
-
Day 1 - Status report
Announcements • 23 Mar 2014, 22:45 • hek 24 Mar 2014, 20:12 -
Some sensors permanently fail after one/two years
Troubleshooting • 25 Jul 2024, 17:17 • Kokosnoot 25 Jul 2024, 17:17 -
Forum Search not working?
Troubleshooting • 4 Oct 2023, 23:33 • Gibber 2 Sept 2024, 20:28 -
Arduino nano and Uno in same My sensors network with NRF24L01+
Troubleshooting • 26 Jul 2024, 10:30 • DIY89 27 Aug 2024, 09:59 -
Raspberry Pi 5: invalid GPIO 9
Troubleshooting • 27 Aug 2024, 13:20 • igo 27 Aug 2024, 13:20