1.4 Beta

[RJ_Make]

@hek

Thanks, I'll do that when I get home later. Just so I'm clear..

To enable debugging: I Remove the "//" before the #define DEBUG ** in and ONLY in** the /libraries/MySensors/Config.h file ? Then upload the sketch again to the sensors? (I don't have to upload the gateway sketch also do I?)

[hek]

@ServiceXp

Yes correct!

[RJ_Make]

@hek

I can only find MyConfig.h file, and DEBUG was already without the "//".

So I noticed something VERY strange. It seems when I have the sensors connected to the computer, they start reading in Fahrenheit, and once I pull the USB cable it reverts back to Celsius with-in 30-60 seconds..

[RJ_Make]

Yep, I have no idea how to debug this. The debug window reads in Fahrenheit, (and in Vera), but 30-60 seconds after I disconnect the usb cable from my computer (at which point I can't use the serial com window) it reverts back to Celsius.

I've deleted one of the sensor nodes and child from Vera, cleared the eEPROM and re-install sketch and re-incuded back into Vera...

I just don't understand why it works while connected to my computer...

[hek]

@ServiceXp

No, this seems strange. The unit settings should get stored in eeprom.

[RJ_Make]

@hek

Do you think I can rule out my sensor hardware as it works with 1.3? Is there any way I can determine if it's being written to eEPROM while connected to the computer and then after it's disconnected (to see if it's getting overwritten)?

[hek]

@ServiceXp

Do you call process() in loop()?

But, really.. Don't put too much effort into this. Just hardcode sensor to send fahrenheit until conversion is done by controller plugin.

[RJ_Make]

@hek
I'm using the boiler plate sketch provided in the 1.4b1 files. The only modifications I've done is add battery code. (Copy and Paste).

How to I hard code sensor to send in Fahrenheit?

Sorry you have to hold my hand through this, I'm very new at this.....

[hek]

@ServiceXp

Change

float temperature = static_cast<float>(static_cast<int>((gw.getConfig().isMetric?sensors.getTempCByIndex(i):sensors.getTempFByIndex(i)) * 10.)) / 10.;

To

float temperature = static_cast<float>(static_cast<int>((sensors.getTempFByIndex(i)) * 10.)) / 10.;

But I still wonder what goes wrong...

[RJ_Make]

@hek

Worked perfectly for the temperature sensor, but it appears the Humidity and Temp. Sketch handles this differently. Not sure what to replace and where.

[RJ_Make]

Not very nice but I think this will work..

  //float temperature = dht.getTemperature();
 float temperature = dht.getTemperature()*9/5 + 32;
  
 if (isnan(temperature)) {
    Serial.println("Failed reading temperature from DHT");
 } else if (temperature != lastTemp) {
 lastTemp = temperature;
   if (!metric) {
  temperature = dht.getTemperature()*9/5 + 32;   //dht.toFahrenheit(temperature);
 }