2 channel relais with 2 buttons sending strange values for on:off

[vampircik]

Used: C:\Users\vampircik\Documents\Arduino\libraries\Bounce2
Not used: C:\arduino-1.6.3\libraries\Bounce2

I tried to upload a sketch, an error says no such library

[Anduril]

@Yveaux yeah I compiled all 2 nodes and the gw just yesterday with the same MySensors version. With Arduino core version you mean the version of Arduino IDE? 1.6.6
Is it necessary/usefull/possible to do a eeprom reset on the gw?
Btw sometimes MYSController does not recognice all presentation messages. Is that somehow a problem? I don't know why this happens as all my nrf are equiped with 4.7µF (node in question also tried with 2 caps).

[mfalkvidd]

This is how to check esp core version http://forum.mysensors.org/topic/2708/soft-wdt-reset-on-esp8266/13

[Anduril]

[vampircik]

these relays your sketch works well, but is not displayed correctly in the controller
http://ru.aliexpress.com/item/2-channel-New-2-channel-relay-module-relay-expansion-board-5V-low-level-triggered-2-way/1617727658.html
and with these relay failures. why is that? although "RelayWithButtonActuator" in truth it works with one group
http://ru.aliexpress.com/item/10PCS-LOT-New-original-solid-state-relay-G3MB-202P-DC-AC-PCB-SSR-In-5VDC-Out/32339505849.html

[Anduril]

@vampircik I don't realy understand what you tried to say. At the moment I have no real relays connected but simply LEDs for testing purposes.
@Yveaux I updated the ESP8266 definitions to ver 2.0.0. But now I can't upload a sketch. I get this message:

warning: espcomm_sync failed
error: espcomm_open failed

Do you know what that means?

[Yveaux]

@Anduril said:

warning: espcomm_sync failed
error: espcomm_open failed

Did you select the right target board & settings? They did make some changes there with 2.0.0

[Anduril]

I just left them on standard as before...
just found one option named " reset mothode" which was ck and now I set it to nodemcu (only option that seems reasonable to me by it's name). Just worked to upload the sketch. I will do further tests and report back.

[Anduril]

Still getting those strange numbers for relay status on or off. I will build another node to test this new constellation.

[Anduril]

Now I tested with a third node the check. Also after node 3 sending data my 0 and 1 from the relay node become large numbers. One thing that seems strange to me is the behavior during reboot of the temp/hum node. First this node is active and sending temp and hum data. Readings from relay are strange as usual. When rebooting the relay signals turn to be 0 and 1 after the temp/hum node has presented itself to the gateway. But after sending the first data for temp/hum it is again receiving those large numbers. Does this make any sense for you @Yveaux?

[Anduril]

I updated my gateway to newest dev version and now my nodes are communicating correctly (not updated, still 1.5.3). So the problem seems to be gone in 2.0, but I think it would still be nice to know what caused it for those not willing to upgrade to dev branch.
For @netram and @kr0815 (and maybe others) who had similiar problems: dev branch fixes this issue.

[netram]

Sweet! Thanks for the feedback @Anduril .