MQTT and Mysensors gateway All in one

[Dylano]

Thanks...

I gonna try it.. [ and read... :-) ]

Only i think it should work in Domoticz...

But i try to start with my sensors..
And then mqtt

[dakky]

this will probably not work: domoticz is waiting for mqtt messages not matching the mqtt messages delivered by mysensors. When using domotitz ethernet or serial gateway is preferable

[Dylano]

So i must make a gw for my sensors....[ uno is the best option? ]
And make a gateway for MQTT?

Thanks

[dakky]

there is only one gateway in your network.

you should proceed the following way:

1. decide which controller to use
2. build gateway, which fits to your controller
3. build the nodes

[Dylano]

Sorry, for my stupids...
My controller is Domoticz...

I want to build a gateway for mysensors and mqtt
What should i make....
I prefer 1 hardware for the 2 protocols

Or is the best option to make 2 different gateways?

[sundberg84]

You can use several gateways in Domoticz (for different protocols), just add them in hardware.
You need to code/create a mqtt gateway for Domoticz since this doesnt excist what i know of.

I think thought using two gateways for MySensors paralell might be hard... dont know if anyone done that but I guess you will recieve the message twice if you have two MySensors gateways to same controller.

[hek]

@sundberg84 said:

I think thought using two gateways for MySensors paralell might be hard... dont know if anyone done that but I guess you will recieve the message twice if you have two MySensors gateways to same controller.

It is possible to have several gateways; Just alter channel or base radio ir (for nrf). But one each node should only be "connected" to one gateway.

[Dylano]

I think thought using two gateways for MySensors paralell might be hard... dont know if anyone done that but I guess you will recieve the message twice if you have two MySensors gateways to same controller.```

Do you have a how to?

[hek]

Just set ret frequency/base-id in MyConfig.h before compiling gw/sensors.

[mountainman]

Is it possible to use the same sensors with both ethernet and MQTT? I am currently using the ethernet gateway with vera but I would like to try MQTT/OpenHab. I would like to see the same sensors in both environments. Is the possible use the mutt gateway with vera?

Thanks in advance.