💬 Sensebender Gateway
-
And ethernet is up!
I think this calls for a couple of pictures of the "thing" :)
first with ethernet / usb (power) connected.
and without ethernet shield
Hi @tbowmo. Congratulations.
Have you identified what caused the trouble?
Regards! -
It was a software issue.. I had rewritten the hardware definition files almost from scratch, and made a couple of errors that made it fail silently..
Peripheral configuration on SAMD21 is a bit more advanced, than on the old atmega328, as you can configure a specific peripheral (a sercom unit for example) to appear on different pins, depending on MUX setting.. I had made some wrong MUX settings for SERCOM4, which is used for the W5100 module.
-
Great work @tbowmo - cant wait until I can get my hands on one :)
Controller: Proxmox VM - Home Assistant
MySensors GW: Arduino Uno - W5100 Ethernet, Gw Shield Nrf24l01+ 2,4Ghz
MySensors GW: Arduino Uno - Gw Shield RFM69, 433mhz
RFLink GW - Arduino Mega + RFLink Shield, 433mhz -
Great work @tbowmo - cant wait until I can get my hands on one :)
-
If you come to the meetup in Malmö, you can see a working prototype :)
Hi @tbowmo .
Would you say that the board is ready for production environement? I am planing in ordering one for my home.
Will you share the sketches for the differente gateways configurations?
Thanks, regards. -
Hi @tbowmo: Nice project. I have a small question about the W5100 board. The board has a standard mail header connector. If I add a (standard) female header, I don't have enough height to compensate for the height of the RJ45 connector. How did you resolve that? Did you use a higher female header? I can't make it up from the pictures.
Thanks in advance,
Ralph
-
Sketches would be the standard sketches for different GW options, as distributed with the mysensors core (it's the same sketches for atmega328p based gateways)
@bisschopsr
Actually a really good question :) I haven't been able to find a header with extra height.. But what I did on my sample, is that the female header is not mounted flush to the PCB, rather it's raised as much as possible above the PCB, and then it is working.I will have to talk with our manufacturing partner in China, and see what they have as options.
-
Any idea when I'm able to order a couple of those? I'm organizing a MySensors master class for visitors of a Fast Data Event me company is holding in September. Would be great if I'd could show and promote this Gateway. I love it.
-
Im talking with the manufacturer, and hopefully we can start a prototype evaluation very soon now. My guess is that we could start shipping within a couple of months from now, if we don't find any mistakes :)
-
It's been a while since my latest update, but I am moving closer to production of this gateway.
I have received the first production samples from Itead
I have done hardware verification of the board. Everything seems to be ok, so we are very near the goal.
I can't say anything about pricing yet, as Itead haven't given us a price yet. But I hope that we will be able to announce that very soon (tm)
Finally a picture with all the connectors added as well
-
Great work!! Cant wait until i can buy one :) Will it be possible to buy in low quantities and ready assembled?
-
-
@tbowmo - thanks and again great work!
-
Can't wait to get my hands on one of these. Building a new network based on the RF69 and need a working Ethernet gateway.
-
We are aiming for a similar setup as for the Sensebender Micro, that is Itead is handling the production and shipping, for us. So yes, they will be SMD assembled, where you have to solder in the connectors that you need.
