Reboot Node
-
Hi.
If good understand then Watchdog is used for low powre timer , when use .sleep function then use this timer for max 8s .
But I need reboot Node . Then how can I do that ?
I use BCD encoder for manuany set Node ID . If want chagne ID then powr Off battery and change position on BCD encoder .. and Powr On and Node set new ID .
But I want do it in my loop function .. if change BCD encoder then in loop I compare BCD ID with Node ID if not equal then
I want reboot node .but how to do it if watch dog is used for timer not reset ??
how use funtion gw.reboot(); ???
regards ..
-
@dzairo search the Web for rebooting arduino from code. There are many ways each with its own (dis) advantages.
1 out of 2
Suggested Topics
-
How does it work? Sleep , WDG ..
General Discussion • 24 Nov 2014, 07:49 • dzairo 28 Nov 2014, 23:20 -
Watchdog on Ethernet Gateway
General Discussion • 18 Feb 2015, 18:48 • BulldogLowell 22 Jul 2015, 17:56 -
Pressure Sensor Node send fails.
Troubleshooting • 27 Jan 2016, 01:06 • Suresh Mali 1 Feb 2016, 21:32 -
Manual assigning node id's for network with repeaters
My Project • 24 Dec 2014, 10:00 • boozz 24 Dec 2014, 16:37 -
No Auto node id
Troubleshooting • 18 Dec 2014, 18:16 • C.r.a.z.y. 25 Dec 2014, 17:30 -
Maximum number of hops in a network
My Project • 27 Dec 2014, 13:17 • boozz 27 Dec 2014, 16:49