connecting existing alarm system to veralite/ mysensors
-
hi, it have an existing home alarm system the dcs pc1565 classic with motion sensors, smoke detectors siren and control panel.
I'm looking to interface the system into my veralite using arduino or raspberry pi b +. But don't know where to start, but would prefer to use the outputs of the alarm system rather than connect directly to the sensors.
Any sketches, plugins, wiring diagrams, code would be much appreciated
-
I will add a photo of the wiring in the alarm panel soon as it has a tamper switch and my partner is asleep
-
@brettzky84 said:
I'm looking to interface the system into my veralite
Have you looked into the DSC plugin for Vera? I don't own one so i do not have experience with it but I have seen the plugin listed within UI5.
see here ---> DSC Vera Plugin
-
there is TONS of this on the Vera website, and many many folks are connecting them with a (serial I think) interface that you may buy and the plugin @Dwalt mentioned.
Suggested Topics
-
💬 learning cube for arduino
OpenHardware.io • 16 Mar 2019, 12:41 • openhardware.io 16 Mar 2019, 14:32 -
Arduino Mini Pro 5v - how to power
Troubleshooting • 3 Sept 2014, 21:43 • ddluk 11 Sept 2014, 03:30 -
💬 NRF24L01 shield for Arduino Uno (for MySensors gateway)
OpenHardware.io • 13 Feb 2019, 21:39 • openhardware.io 13 Feb 2019, 21:39 -
Car battery health monitoring and alerts system with IoT integration
My Project • 7 Jan 2021, 20:57 • William Meli 10 Jan 2021, 11:51 -
Problem with light control between mysensors and HA
Troubleshooting • 7 Jan 2019, 08:55 • Misna 9 Jan 2019, 07:17 -
How to great variables
General Discussion • 16 May 2024, 14:43 • wint0178 22 Jul 2024, 06:11 -
💬 NodeManager
OpenHardware.io • 23 Mar 2017, 22:45 • openhardware.io 26 May 2019, 18:10 -
Custom Interrupt routine for door sensor
Development • 11 Jan 2015, 16:27 • funksoulbrother 11 Jan 2015, 22:00