Got the Gravitech in the mail today. First try - recognized! Now to build some sensors. Thanks guys for the help!

Making a SSH connection to Veralite i managed to see the LuaPNP.log and found that a xml file had been corrupted and was not found anymore. Now everything works fine !

@brettzky84 there is TONS of this on the Vera website, and many many folks are connecting them with a (serial I think) interface that you may buy and the plugin @Dwalt mentioned.

i found some information here that may be of some use for others http://openenergymonitor.org/emon/node/58

Thanks for the reply. I am not looking to use an LCD, although that may be the best solution. For now, I plan on creating a simple set of LEDs and buttons. I have looked over the code, and was wondering which part of the code is retrieving the status of a sensor? What if I have multiple motion sensors, how would I retrieve each unique value?

ok - thanks guys

@Dean said: @CaptainZap said: I've tried flashing the gateway with IDE and I get a compilation error on line: MyGateway gw(DEFAULT_CE_PIN, DEFAULT_CS_PIN, INCLUSION_MODE_TIME, INCLUSION_MODE_PIN, 6, 5, 4); saying that 'MyGateway' does not name a type. Any ideeas ? Thanks. LE: Figured it out... my bad, compiling now. LLE: Still doesn't work :| LLLE: Tried using these chinese nano ripoffs but they are not detected at all by Vera. These CH340G chips suck so bad... My only way of getting this to work is with my Uno. Will appreciate any help anyone can provide. I have the same problem, can you share what you did to resolve the issue? Bought an FTDI arduino nano...

I'll admit a newbie at this. but I"m about beyond frustrated. I've been trying to get my "Vera Edge" Serial gateway up and running. I had it working, using a nano ATmega328 w/FTDI chipset. So that was great! All your posts were very helpful! So I decided to move forward and start building my sensors. The first sensor I built was a motion sensor also using a nano ATmega328. So I got it up and running, communicating with the gateway, and than the Vera controller dropped it and I kept get the same error message, Device not ready, "LUA Startup Failure. If you all have any another ideas on what could be causing this I could sure use your help! Thanks